For the Morph, these options are also available individually and separately for each face.Sometimes I like that archicad is less rigid than Revit. Such faces are displayed (in OpenGL and rendering) as smooth and curved.Īs with other 3D elements, if you have applied a surface that includes a texture, you can use the Align 3D Texture command to fine-tune the origin and rotation of the texture pattern. A soft edge is an internal sub-element that divides segmented faces. By default, they are hard if you reset an edge to be “soft,” then its adjacent faces will behave as though merged into a single, flexible face. Hard or Soft Edges: in the Info Box or Morph Settings, any edges can be individually re-set to be “hard” or “soft”.In addition, a number of commands allow you to transform the Morph with a single click, by smoothing or subdividing its sub-elements, and also gives you some control over the smoothing mechanism. Morph surfaces are defined by faces, and as you edit the Morph, its many segments are automatically smoothed to create curved surfaces. Morphs can participate in priority-based connections with other elements, provided that you merge them using the Design > Connect > Merge Elements command.Unlike Solid Element Operations, which create connections, Solid Morph Operations are not associative - the final result of the operation is permanent. There are separate Solid Operation commands for Morphs.Morphs (like Shells) can be input onto any plane of the 3D window, and with many editing interactions, you can also switch the editing plane as you go, so that there are few constraints.Notice that Fillet and Chamfer are available for Morphs in the 3D window, applied to any or all edges or corners. Graphical interface uses familiar methods and interactions: select any edge, grab any point or surface, or any combination of their sub-elements, to modify the Morph with the help of the pet palette and real-time feedback. Morph creation and editing is most intuitive in the 3D window.In sub-element selection, only the Model panel is available, and only the relevant controls are available, depending on whether you have selected edges, faces or a combination thereof. Morph Selection Settings varies depending on whether you have selected an entire Morph, or any combination of its sub-elements (e.g.By default, Morphs (as well as Shells) are displayed on the Floor Plan in true 3D projection mode. The Floor Plan and Section controls are similar to those of the Shell Tool.In Morph Settings, you will notice that there are no numerical geometric parameters, apart from its default elevation. ![]() These can be used for sketching or documenting purposes. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |